300Tdi Defender
AIR CONDITIONING
3
REPAIR
CONDENSER FAN AND MOTORS
Service repair no - 82.15.08
Remove
1. Disconnect battery.
2. Remove 6 screws and lift grille panel from
vehicle.
3. Disconnect fan motor multi-plugs and release
harness retaining clips.
4. Remove nut and washers and withdraw fan
blade from motor drive shaft.
5. Remove 2 retaining screws, release motor fan
from shroud support brackets and feed motor
multi-plug lead through appropriate aperture.
Refit
6. Feed motor lead through fan shroud.
7. Fit motor to fan shroud support brackets.
8. Reconnect fan lead multi-plug and secure with
retaining clips.
9. Fit fan blade to motor drive shaft.
10. Fit grille panel.
11. Reconnect battery.
CONDENSER
Service repair no - 82.15.07
Remove
1. Disconnect battery.
2. Recover refrigerant from air conditioning system
See Adjustment, Refrigerant recovery,
recycling, recharging.
3. Remove 6 screws and lift grille panel from
vehicle .
4. Disconnect condenser fan motor lead
multi-plugs.
5. Disconnect receiver/drier dual pressure switch
multi-plug.
6. Disconnect condenser low pressure pipe at
compressor.
7. Disconnect high pressure hose/pipe at
evaporator.
