L322 Range Rover Service Procedures
ENGINE - V8
OVERHAUL 12-2-85
8. Fit LRT-12-218 to crankshaft, apply a thin coat
of oil to inner lip of crankshaft rear oil seal, fit
seal housing over LRT-12-218 onto dowels and
remove LRT-12-218.
9. Fit new sealing washers to 6 Torx bolts, fit 6
Torx bolts and 6 bolts securing crankshaft oil
seal housing to cylinder block and tighten to 12
Nm (9 lbf.ft).
10. Fit torque converter drive plate.
Gasket - cylinder head
$% 12.29.02.01
Remove
1. Remove 8 nuts securing exhaust manifold,
remove exhaust manifold and discard nuts and
2 gaskets.
2. Remove coolant pump to coolant manifold
Engine - V8, OVERHAUL, Pipe(s) -
water pump to coolant manifold.
3. Remove LH VCC unit.
Engine - V8, OVERHAUL, Variable
camshaft unit - variable camshaft control
(VCC).
4. Remove LRT-12-227 from timing tool access
hole.
M12 7993
LRT-12-227
