L322 Range Rover Service Procedures
BRAKES
70-20
REPAIRS
Sensor - pad wear - rear
$% 70.40.05
Remove
1. Raise rear of vehicle, one side.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove RH road wheel.
3. Remove 5 screws securing wheel arch liner
and release liner for access to multiplug
housing.
4. Open cover on multiplug housing, release and
disconnect pad wear sensor multiplug then
release sensor lead from spring turret,
suspension arm and bleed screw dust cap.
5. Disconnect pad wear sensor from brake pad.
6. Remove sensor.
Refit
1. Fit sensor to pad.
2. Secure sensor lead to bleed screw dust cap,
suspension arm and spring turret then connect
and secure multiplug. Close multiplug housing
cover.
3. Locate wheel arch liner and secure with
screws.
4. Fit road wheel and tighten nuts to 140 Nm (103
lbf.ft).
5. Remove stands and lower vehicle.
