LR3/Disco 3
Camshaft Position (CMP) Sensor (18.30.24)
Removal
Installation
Published : May 21, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the engine cover. For additional information, refer to
Engine Cover - 4.4L (12.30.50)
(Section 501-05)
3 .
NOTE :
Removal of the RH is similar to this procedure.
Remove the CMP sensor.
Disconnect the electrical connector.
Remove the Torx screw.
Discard the O-ring seal.
1 .
To install, reverse the removal procedure.
Clean the component mating faces.
Install a new O-ring seal.
Tighten the Torx screw to 7 Nm (5 lb.ft).
